Readers for RFID tags and PIN code and fingerprint for access controllers

Active RFID reader antenna for contactless EM Tags, Cards, Keyfobs Tamper-proof mounted, the controller is in the security area Sabotage attempts on the antenna are ineffective Integrated LEDs and beeper Waterproof cast, suitable for outdoor applications Dimensions: 115x75x15mm Power supply: 12V DC Current consumption: approx 45mA Interface: RS232 2 wires for data transfer (send and receive) The cable length to the controller can be up to 100m. Reading distance: up to 10cm Transponder type: 125 kHz, EM4102, EM4100, EM4200, Unique or compatible (UID) kompatible with: KEYFLEX 1000 aktiv SEBURY W1 SEBURY W2 SEBURY K3A SEBURY K4A SEBURY BC2008NT SEBURY BC800NT1 SEBURY BC800NT2 SEBURY BC800NT4 SC901NT SC902NT SC904NT

Active RFID reader antenna for contactless ISO14443 ® tagSabotage safe full metal caseSecure the sabotage because the controller is mounted into the security restricted areaSabotage attempts are ineffective on the antennaIntegrated LEDs and beeperWaterproof, suitable for outdoor applicationsDimensions: 121x80x26mmPower supply: 12V - 18V DCPower consumption: approx. 45mATemperature range:-20 ° C to 60 ° CProtection class: IP68Cable length: 3 mRead speed: 0.1 secondsInterface: Wiegand 262 wires for data transfer (sending and receiving)The cable length can be up to 100 m up to the controller.Reading distance: up to 6 cmTransponder type: 13.56 MHz, ISO14443 1 k or 4 k compatible to: KEYFLEX 1000 aktiv SEBURY W1 SEBURY W2 SEBURY K3A SEBURY K4A SC3001NT SC3002NT SC3004NT

The RTU5024 is a remote switch which is controlled via a mobile radio. It can be used for all safety-relevant applications, as for the switching operation, the phone number of the inserted SIM card must be known and it can be triggered only by previously set telephone numbers.The programming is pretty easy with an Android App . A call of an authorized phone number is sufficient to trigger the switching operation. There is no cost, because of the RTU5024 of the call is not accepted, but checks only the number of the caller. For all "non-Android phones", you can easily set up the RTU5024 with the enclosed, German instructions via SMS commands. When you set up, you may incur costs for SMS.The actual use as access control is free. German manual is supplied orderQuad-band 850/900/1800/1900 MHzPotential-free relay output NO/NC, 3A/240VACPower supply 9-24VDCPower consumption at 12V Max 50mA, standby 25 mA50 ohm SMA antennaWorking temperature-20 ° C to + 60 ° CHumidity up to 90% RHDimensions 76 x 27 x 102 mm (Lxhxw)Weight 180 g

Wireless RFID Mifare Wiegand reader For doors without a power connection on the outside as well as for opening the door directly from the workplace or reception, this reader with battery operation can be used immediately without wiring. The Wiegand code is transmitted to the access control by radio after the transponder or RFID key fob is placed on the door and then the door relay is released after checking the authorization in the access control unit.  Radio range up to 30m Wall-mounted transmitter Dimensions: 120x50x20mm 3 AAA batteries required Transfer in 433 Mhz rolling code 13.56 Mhz,   Output: Wiegand 26 / 34bit including board receiver 12VDC Dimensions: 50x25mm Operating instructions PDF

Active RFID reader antenna for universal contactless ISO14443 tags, cards, label, fobs Tamper-proof because the transmitter is mounted in the security area is Sabotage attempts on the antenna are ineffective Intergrated LED and beeper Water resistant, suitable for outdoor applications Dimensions: 100x42x16mm Housing Color: Black Power supply: 12V DC 2 wires for data transfer (send and receive) The cable length to the controller can be up to 100m. Transponder read distance: up to 8cm Transponder type: EM4102, 125 kHz Optional Accessories:Installation cableTCP-IP controllerorCompact controllerCompatible Tags, Cards, Key Fobs, Label

Active RFID reader antenna for contactless EM tagsSabotage-Safe full metal case Tamper-proof mounted  controller in the security area Sabotage attempts on the antenna are ineffective Integrated LEDs and beeper Waterproof cast, suitable for outdoor applications Dimensions: 121x80x26mm Power supply: 12V - 18V DC Current consumption: approx 45mA Temperature range: -20 ° C to 60 ° C. Protection class: IP68 Read speed: 0.1 second Interface: Wiegand 26 2 wires for data transfer (send and receive) The cable length to the controller can be up to 100m. Reading distance: up to 6cm RFID type: 125 kHz, EM4102, EM4100, EM4200, Unique or compatible (UID) Optional accessories:Installation cableTCP-IP controllerorCompact controllerCompatible Tags, Cards, Key Fobs, Label

Fingerprint reader and RFID reader for universal RFID tags Solid steel casing 2160 memory locations (160 fingerprints, 2000 tags) Fingerprint or RFID tag can open "the door" Deleting of absent users or lost tags is possible Wiegand controller and integrated Use as a standalone device (default) Use as a pure controller (also for antennas (LEGIC, ISO14443, Hitag, etc.) Use as possible Wiegand Reader (with Sure sabotage controller in the security area) An output circuit with two EM-F007 possible Lock function with two EM-F007 possible External door opener button can be connected Tamper switch in the case Connection for door contact For doors, gates, garages, shutters, etc. 12V switched output 01-10 seconds adjustable (open-circuit or closed circuit) Switching time of the alarm output (sabotage) 0-3 minutes adjustable Fail-safe EEPROM memory power No PC connection blue backlit touch panel Intergrated LED and beeper Transponder read distance: up to 6cm Finger Sensor Resolution: 450 dpi Reading time: <1 sec Indentification time: <1 sec FAR: < 0,00002561% FRR: < 0,0198% Dimensions: 115x70x35mm Weight: ca.500gr Power supply: 12V DC (8-14V) Power consumption: about 20-90mA Temperature range: -20° C to 60 ° C. Output load: 20A maximum (short circuit) RFID type: Universal 125kHz (EM4102 or compatible) including interface: Wiegand 26 bit Installation and operating instructions Installation cableTCP-IP controllerorCompact controllerCompatible Tags, Cards, Key Fobs, Label  

Sebury sTouch wide keyboardTamper -proof outdoor unitElegant and robust aluminum housingWaterproof IP65Wear- through touch keyboard thereforeno traces of useEasy to clean due to smooth , scratch-resistant surfaceTouch pad and RFID reader for contactless transponderData connection to a controllerData output: Wiegand 26-37 bitsTamper switch in the housingIntergrated LED and beeperAudible alarm if tamperingLed out door bell button with two cores RFID reading distance : up to 3 -10cmDimensions STOUCH : 125x83x22mmPower supply: 12V DCCurrent: 35mATemperature range: -40 ° C to 60 ° CIndicator : multi-function display (can be deactivated )Keyboard Illumination: white ( can be switched off or automatic on approach )Key tones (defeatable )Readable transponder types :125 kHz ( HID Prox , EM4100 , EM4102, EM4200 or compatible) Unique / UniversalScope of delivery:- Outdoor unit / access host STOUCH reader -R w- Small and Fixings- 2 tickets Manager ( Learning and delete card )- Manual (english) Print- Manual ( German ) as PDF   PDF- Manual Download   Optional AccessoriesInstallation cable by meterTags's: EM or HIDDoor OpenerController Network Controller Compact Doorbell decoder  

Sebury sKey wide keyboardTamper -proof outdoor unit without saving- Elegant and robust aluminum housing- Waterproof IP65- Illuminated Metal Keypad and RFID reader for contactless transponder- Data connection to a controller- Delivery without door controller- Data output: Wiegand 26-37 bits- Tamper switch in the housing- Intergrated LED and beeper- Audible alarm if tampering- Bell button directly led out ( internal resistance of about 80 ohms) for electronic Gong ( max. 10mA )  or Doorbell decoder- Transponder reading distance : up to 3 -10cm- Dimensions sKey R w: 125x83x22mm- Power supply: 12V DC- Current: 35mA- Temperature range : -40 ° C to 60 ° C- Status display : multi-function display (can be deactivated )- Keyboard Backlight : white, On or Off , or Auto ( the 1st press ON , 30 sec OFF)- Keypad tones (can be disabled )Readable transponder types :125 kHz- HID Prox- EM4100 , EM4102 , EM4200 or compatible) Unique / UniversalScope of delivery:- Outdoor unit / Access host sKey reader -R -w- Small and fixing material- Manual (english) Print- Manual ( German ) as PDFPDF- ManualOptional AccessoriesInstallation cable by meterTags's: EM or HIDDoor OpenerController Network Controller Compact Doorbell decoder  

Sebury  sTouch wide Stand alone access control system with PIN Code and ISO14443 tags Can be used as a complete device with integrated memory and relay outputoras tamper-resistant  reader  connected with a door controller -Elegant and robust aluminium housing-Waterproof IP65-Illuminated metal keyboard and RFID reader for contactless transponder-2000 memory locations for key codes and transponder-Adjustable: Code or transponder code transponder or only transponder-additional data output for professional applications: Wiegand 26-37 bit-Tamper inside-Integrated led and beeper-Acoustic alarm for sabotage-Alarm output-integrated AC relay-Circuit as impulse 1-99 seconds- or as a permanent circuit on off on off for switching functions-Push button directly deduced (internal resistance approx. 80 ohms) only for electronic chime (max. 10mA)or doorbell＞ decoder-Multi user feature, 2-10 persons to identify themselves before the door is opened.-Circuit as a single unit or as anti-PassBack with two readers for a door-Reading distance tag: up to 3-10cm-Mass sTouch w: 125x83x22mm-Power supply: 12V DC-Current: 35mA-Temperature range:-40 ° C to 60 ° C-Indicator: multi function display (can be switched off)-Keypad illumination: white (can be switched off or automatic approach)-Keypad tones (can be switched off) Readable tag types:13,56 MhzISO14443 1k, 4k, 4byte or 7byte PRODUCT COMPARISON Scope of delivery:-Outdoor unit/access host sTouch standalone wide-Manager cards (learning and deleting card)-Small - and fixing material-Manual (English) print-Guide (german) as PDF Manual Download Optional AccessoriesInstallation cable by meterDoor OpenerController Network Controller Compact Doorbell decoder    

Compact access control system The door can be opened by fingerprint or tag or with PIN code Touchless transponder technology RFID Failure safe EEPROM memory Connection for door chime For up to 3000 people Power saving Connection for door contact LED status indicator Transponder cards as keychains available Cover contact (tamper) Relay output for door opener Connection for external opening button Alarm output Wiegand 26bit data output for door controller Now with managing card Input voltage DC 12 V Power consumption 100mA Dimensions 155 x 66 x 28 (mm) Weight 206 g incl. packaging and accessories Temperature range -20°C to 50°C Humidity 20% - 80% Capacity: 3000 user RFID Chip type: EM4102 and compatible Transponder reading distance of 3-10 cm Manual Optional Accessories: Installation cableNetwork controllerorCompact controllerCompatible Tags, Cards, Key Fobs, Label